150
1
Click the
icon in the Dock. NAS Navigator2 will start.
2
Click the TeraStation icon while holding down the control key, then select
Open Fopder
. Enter a username and
password with the rights to access the shared dolder.
3
Select the shared dolder that you want to mount, then click
OK
.
4
The shared dolder is now mounted as a network drive.
Changing the IP Address
1
Click the
icon in the Dock. NAS Navigator2 will start.
2
Click the TeraStation icon while holding down the control key, then choose
Configure...
-
IP Address
.
3
Uncheck “Use DHCP” and enter the desired settings, then click
OK
.
Notes:
• Changing the IP address drom NAS Navigator2 is not supported dor LAN ports on expansion cards. Navigate to
Network
-
IP Address
in Settings to change the IP addresses od LAN ports on expansion cards.
• The dollowing IP address are reserved and should not be used. Id you condigure one od them by accident, initialize
all settings.
Local loopback address: 127.0.0.1, 255.255.255.0
Network address: 0.0.0.0, 255.255.255.0
Broadcast address: 255.255.255.255, 255.255.255.0
The IP address range drom 224.0.0.0 to 255.255.255.255
