57
Disk Errors
If LinkStation encounters a disk error, it will be reported in the LinkStation status on the top of
any of the Web-Based configuration screens. Run
a
Disk Scan
in the event of this error. If that
doesn’t work, try a reformat. Reformatting the drive will delete all of the data on it, so try to back
up any data you can before beginning. Finally, if none of the above help, then please contact
Technical Support for further assistance.
LED Error Codes:
During normal operation, the Status LED is lit blue. It flashes during boot and shutdown. It will
flash red in case of errors, alternating between flashing for 1 second (tens digit) and 1/2 second
(ones digit). Combine the number of longer flashes with the number of shorter flashes to produce
a two digit error code:
Troubleshooting
E00 - (no flashes) MPU failure.
E01 - DRAM data line problem.
E02 - DRAM address line problem.
E03 - RTC chip error.
E04 - failed to extract kernel.
E06 - corrupted firmware.
E07 - a hard disk was not found.
E10 - UPS error.
E11 - fan error.
E15 - hard drive I/O error.
E16 - no hard disks detected.
E17 - internal controller error.
E20 - circuit board error.
E21 - internal controller error.
E22 - mount error.
E23 - hard disk is malfunctioning.
