3
Check the LINK/ACT light on the front of the LinkStation. If it is lit, then
LinkStation is connected properly; please turn to
Page 4
to continue
setup. If it is not lit, continue to the next step.
On the back of LinkStation, fl ip the black
‘Cable Selection’
switch. This
switch tells LinkStation whether to communicate over a Crossover or
Patch cable. NOTE: Newer LinkStation products use MDIX Auto-Sensing
LAN ports and do not have nor require the Cable Selection switch.
Verify that the LINK/ACT light on the front of LinkStation is lit (see
Step 4
’s
picture). If it is lit, turn to
Page 4
to contintue setting up LinkStation. If the
LINK/ACT light is still not lit, please verify the following:
If problems still persist, contact our 24/7 technical support at
1(866) 752-6210
Both LinkStation and the hub, switch, or router are powered on.
The Ethernet Cable is securely fastened to both devices.
The Ethernet Cable is not damaged. To verify this, try using
another Ethernet Cable. When verifying new cables, remember
to switch the black ‘Cable Selection’ switch to both positions.
LinkStation Setup
