PS07570 MIG135 115 V MIG Welder Assembly & Operating Instructions Manual
3
COMMON SENSE AND CAUTION ARE FACTORS WHICH CANNOT BE BUILT INTO ANY PRODUCT.
THESE FACTORS MUST BE SUPPLIED BY THE OPERATOR.
Keep your work area clean and well lit.
Cluttered work benches and dark work areas may cause
accidents or injury.
Keep bystanders, children and visitors away while operating the
compressor
.
Distractions can
cause you to lose control.
Do not force tool. Use the correct tool for your application.
The correct tool will do the job better and
safer at the rate for which it is designed.
Store idle tools out of reach of children and other untrained persons.
Tools are dangerous in the
hands of untrained users.
Use common sense while operating this welder.
Do not use this tool if you are:
•
Feeling tired or are under the influence of alcohol or drugs.
•
Wearing loose clothing or jewelry. Keep long hair pulled back and away from moving parts.
•
Overreaching or have improper footing. Handling the tool in this way could cause serious injury.
•
Wear the proper safety equipment, such as safety goggles, dust masks, non-skid shoes, etc.
•
Check to be sure all adjusting keys or wrenches have been removed before use.
Safety glasses and ear protection must be worn during operation. Wear eye protection (see ANSI
Z49.1 safety standard) while cutting to protect your eyes from harmful UV and IR ray’s.
Read the manual carefully. Learn the tool's applications and limitations, as well as specific potential
hazards peculiar to it.
Ground all tools. If the tool is equipped with three-pin plug, it should be plugged into a three-pin
electrical socket. Never remove the ground pin.
Avoid body contact with grounded surfaces such as pipes, radiators, ranges, and refrigerators. There is
an increased risk of electric shock if your body is grounded.
Do not expose tool to moisture. Don't use this tool in damp or wet locations: Keep out of rain.
Do not abuse cord. Never use the cord to carry tools or pull the plug from an outlet. Keep cord away
from heat, sharp edges or moving parts. Replace damaged cords immediately. Damaged cords
increase the risk of electric shock.
Don't overreach. Keep proper footing and balance at all times when operating this tool.
Disconnect the tool from power source before making any adjustments, storing, servicing, or
changing accessories. This will reduce the risk of starting the tool accidentally.
Do not force tool. Use the correct tool for your application. The correct tool will do the job better and
safer at the rate for which it was designed.
