PPWASH20 Portable 20 Gallon Parts Washer Assembly & Operating Instructions
8
ASSEMBLY
Do not turn the power switch on until the Parts Washer has been completely assembled.
Failure to do
so could result in serious injury or electric shock.
Unpack product from package and review contents. Keep all packaging until product has been
reviewed.
Lower Shelf
1. Locate the two Handles and the Lower Shelf.
2. Align the holes in the bottom of the Handles with the 4 holes
in the corners of the Lower Shelf.
3. Place Flat Washer onto Bolt and insert Bolt through
Handle and Lower Shelf.
4. Place Flat Washer and Lock Nut onto end of Bolt
and hand tighten.
5. Repeat steps 3-4 for remaining holes in Lower Shelf.
Note: Do not fully tighten nuts at this time.
Middle (Parts Drying) Shelf
1. Locate the Middle Shelf and the Tank Drain.
2. Insert the Tank Drain into the slots located in the bottom of
Middle Shelf.
3. Align the holes in the 4 corners of the Middle Shelf with the
holes in the middle of the Handles.
4. Place Lock Washer onto Bolt and insert Bolt through Handle and Middle Shelf.
5. Thread end of Bolt into the nut welded on inner wall of Middle Shelf and hand tighten.
6. Repeat steps 4-5 for remaining holes in Middle Shelf.
Note: Do not fully tighten nuts at this time.
Tank Mounts
1. Locate the Left Tank Mount and Right Tank Mount.
Note: Right Tank Mount has hooks for electrical cord storage.
2. Align the holes in the Left Tank Mount with the uppermost holes in either Handle.
3. Place Flat Washer onto Bolt and insert Bolt through Handle and Left Tank Mount.
4. Place Flat Washer and Lock Nut onto end of Bolt and hand tighten.
5. Repeat steps 3-4 for remaining hole in Left Tank Mount.
6. Align the holes in the Right Tank Mount with the holes in the remaining Handle. Hooks on Right
Tank Mount should be facing AWAY from center on unit.
7. Follow steps 3-5 to install Right Tank Mount.
Note: Do not fully tighten nuts at this time.
Tank
Note: You may need a second person to help properly align the Tank to the Tank Mounts.
1. Place Flat Washer onto Short Bolt and insert through hole in Tank Mount.
2. Place Adjusting Washer onto Short Bolt.
3. Slide the end of the Short Bolt through the hole in the mounting bracket on Tank bottom.
4. Place Flat Washer and Lock Nut onto end of Short Bolt and hand tighten.
5. Repeat steps 1-4 for remaining seven holes in Tank Mounts. Note: The Power Switch is on the RIGHT side of the Tank
and should be positioned above the RIGHT Tank Mount.
Tightening the Hardware
1. Fully tighten all of the Lock Nuts onto the bolts which were installed in the previous section.
