2
The worklight is shipped with a minimal charge in the internal battery pack. The Initial Charging Procedure
must be completed before first use to ensure proper battery life and performance. Failure to follow
described charging procedures could permanently damage the internal battery pack. The power light will
turn red during charging, and will turn green when the charge is complete.
CHARGING THE RECHARGEABLE BATTERY
110–240 V AC or 12 V DC Charging (adapters included):
1.
Plug the DC output plug from either adapter into the DC IN PORT of the unit and then plug
the 110–240 V AC or the 12 V DC adapter into the appropriate electrical socket (depending
on which charger is being used).
2.
Unplug charger after a full charge is achieved (about 5 hours with 110–240 V charger)
3.
It is best not to use the AC adapter for direct use as this will reduce the life of the battery.
WORK LIGHT OPERATION
1.
The Work Light may be used with the included STAND-ALONE BASE.
2.
To attach it to the BASE, remove the MOUNTING BOLT and place the light on top,
aligning the hole in the mounting bracket to the hole in the base and replace the bolt by
finger tightening them securely. No tools are required.
3.
Toggle the ON/OFF switch to (O) for OFF or single LINE or double LINE for Full or Half
Power. (FIGURE B)
4.
Adjust the angle of the light by grasping the PADDED HANDLE and tilting the face of
the Work Light up and down or swiveling right to left.
TECHNICAL INFORMATION
SPECIFICATIONS: LED BULBS 8 Watt
INTERNAL RECHARGEABLE BATTERY 3.7 V, 3600 mAh Lithium ion battery
230V AC/DC WALL CHARGER Input: 230 V AC - 50/60 Hz
Output: 5 V DC - 1000 mA
12V DC VEHICLE CHARGER Input: 12–24 V DC
Output: 5 V DC - 1000 mA
CONSTRUCTION Weather resistant aluminum
DIMENSIONS (with base) 145 x 167 x 240 mm
CHARGING & OPERATING TIMES
Full Charge Time: 5 hours (230 V AC charger included)
Operating Time: 4+ hours
Eye Safety
DO NOT LOOK DIRECTLY INTO THE LED’S.
Do not shine them into the eyes of the others. As with other
high intensity light sources, eye damage may occur.
Do not leave the light outside and uncovered.
The Work Light is not constructed to be water proof.
Moisture may cause corrosion in the circuitry and result in the premature failure of this product.
Do not attempt to remove or replace the LEDs. LEDs may last up to 50,000 hours and are not replaceable.
202103
FIGURE B
LIGHT OPERATION
ONE LINE = FULL POWER
O = OFF
TWO LINE = HALF POWER
(At half power, all LED lights
are 50% dimmer)
A
C
Includes:
A)
Cable
B)
12V DC Charging Adapter
C)
110–240V AC Charging
Adapter
