Buffalo Tools KSPLIT19, Инструкция по эксплуатации

Страница: 14 / 31

KSPLIT19 GASOLINE POWERED KINETIC LOG SPLITTER INSTRUCTION MANUAL
14
OPERATION INSTRUCTIONS
The diameter listed is indicative of the maximum suggested size. A small log can be difficult to split when it contains
knots or a particularly tough fiber. However, it may not be difficult to split logs with regular fibers even if its diameter
exceeds the maximum indicated above.
•
Max. Log Length: 21 inches
•
Max. Log Diameter: 13.75 inches
•
Never attempt to split wood across the grain. The Log Splitter was not designed for cross-grain splitting. Doing so could
damage the Log Splitter and may cause personal injury.
•
Make sure both ends of the log you are splitting are cut as square as possible. This will prevent the log from sliding out of
position while under pressure.
THE KINETIC LOG SPLITTER OPERATES DIFFERENTLY THAN A HYDRAULIC SPLITTER. OPERATE THE
MACHINE PROPERLY OR RISK DAMAGE TO THE MACHINE. ALWAYS FOLLOW THESE NOTICES:
•
The Engagement Handle should be engaged in rapid movement in order for the Rack and Pinion to engage and
disengage fully without damage.
•
Do not stop the Engagement Handle in any location between the fully forward or fully backward positions.
•
Do not hold the Handle in the forward position when the Ram stops moving forward. Always pull the Engagement Handle
RAPIDLY to the back (Auto-Retract) position as soon as the Log is split or when the Ram is at the end of the stroke or when
the Ram stops moving forward due to a tough log.
1. Place the log on the Log Splitter. Grasp the log on the sides near the middle of the block. Center the log, side-to-side,
on the rail of the Log Splitter, making sure that one end is against the Splitting Wedge.
2 The engagement Handle must be held fully in the Split Position against the hard stop when splitting. Failure to do so
may result in kickback of the Handle.
3. Move the Operation Handle from Lock to Unlock, then the other hand Rapidly moves the Engagement handle
4. IMMEDIATELY AFTER the log is split, actuate and hold the Engagement Handle to the Auto-Retract position to allow
the Ram to return. If the Ram stops before the end of the stroke while splitting a tough log, quickly actuate the
Engagement Handle back to the Auto-Retract position.
Splitting Tough Logs
If the Ram stops before the end of the stroke while splitting a tough log, quickly actuate the Engagement Handle back to
the Auto-Retract position. Let the Ram return and allow the flywheels to gain momentum for another full power split.