Buffalo Tools GEN4000DF-STW, Инструкция по эксплуатации

Страница: 35 / 46

GEN4000DF-STW 4000 Surge Watt / 3500 Running Watt Portable Dual Fuel Gen Welder 35
WELDER USAGE
The Stick Welder is a DC only inverter stick welder with a smooth stick welding performance. It is intended for use
for welding steel, stainless steel, cast iron and hard surfacing using electrodes from 1/16 inch to 3/32 inch. This unit
can also perform lift start DC TIG welding on steel and stainless steel materials with the optional TIG Torch. (Argon
shielding gas along with a regulator, gas hose, and TIG filler rod would also be required for TIG welding.) The
removable quick connect weld cables allow for easy connection, tear down, and polarity changes. It is designed to
weld mild steel and alloys with electrodes up to 3/32" on materials up to 1/8" thick.
Stick welding gives the operator the flexibility to use this welder for mobile applications, including outdoor applications.
Stick electrodes contain a flux, making welding easy and does not require the use of a separate shielding gas which can
be blown away by the wind in outdoor applications. Since this welder does not use shielding gas, the operator will not
require to have or maintain shielding gas bottles, a regulator or gas hose. TIG welding does require the use of Argon
shielding gas. The shielding gas replaces the flux that is used in TIG welding, providing a more controlled and cosmetic
weld. However, TIG welding is limited to areas inside or where wind can be controlled, preventing the shielding gas from
blowing away.
Use on a 20 amp 115V AC circuit without the use of an extension cord. If an extension cord is necessary for your
application, use the appropriate size and length of extension cord to handle 20 amps the entire length of the extension.
Talk with a qualified electrician for cord size recommendations.
WELDER TECHNICAL SPECIFICATIONS
Item Description
Power Supply 120V, 25.7A, 60 HZ, Single Phase
No-Load Voltage 72 Volts DC
Output Range 10 - 85 Amp DC
Duty Cycle 25% @ 85A
Suggested Electrode E6011, E6013, E7018, Stainless Steel
Electrode Diameter
1/16 in, 5/64 in, 3/32 in
Inverter Power Will Maintain Fluctuations In Input Power For Better Welding And Dependable Output
Welds Carbon Steel/Stainless Steel
Thermal Overload Protection & Arc Force
Over/Low Voltage Protection, Anti-Sticking, & Hot Start
Welds Up To 1/8˝ With 1/16 in., 5/64 in. or 3/32 in. Electrodes
10 - 85 AMP Welding Range
Input Voltage: 120V - 60 Hz
Rated Duty Cycle: 25% @ 85A
WELDER IMPORTANT SAFETY CONSIDERATIONS
1.1
Your Welding Environment
- Keep the environment you will be welding in free from flammable materials.
- Always keep a fire extinguisher accessible to your welding environment.
- Always have a qualified person install and operate this equipment.
- Make sure the area is clean, dry and ventilated. Do not operate the welder in humid, wet or poorly ventilated areas.
- Always have your welder maintained by a qualified technician in accordance with local, state and national codes.
- Always be aware of your work environment. Be sure to keep other people, especially children, away from you while
welding.
- Keep harmful arc rays shielded from the view of others.