CGGUN20 Cordless Grease Gun Assembly & Operating Instructions
6
BATTERY CHARGER
Unplug the battery power source before assembly, adjustments, or adding/removing accessories.
The Battery Pack’s terminals will fit this Charger only. Do not use the Battery Pack if it does not fit the Charger. Do not force a Battery Pack
into the Charger.
For best performance on a new battery you must discharge it completely to get full use of the batteries life cycle. Using a battery that has
been charged before it is completely discharged will shorten the batteries total amount of charge it will take in future charging. Be sure to
discharge the new battery completely before charging. All New grease guns come with 80% charge from the factory and no charging is
needed until it is used and the battery is completely discharged.
NORMAL CHARGING
CAUTION:
Charge the battery pack in clean and dry location. Do not charge the battery pack in air temperatures below 48°F (9°C) or above
105°F (41°C).
CAUTION:
Make sure power circuit voltage is the same as the shown on the charger specification.
1. Remove the battery pack from the cordless grease gun by depressing the button on the battery pack.
2. Plug the charger into power outlet before inserting battery pack.
3. Insert battery pack in to charger. Lights on charger indicate the charging process as below:
GREASE GUN OPERATION
Unpack product from package and review contents. Keep all packaging until product has been reviewed.
Loading the Grease Gun with a Grease Cartridge
1. Turn the screw counterclockwise to open the Vent Valve.
2. Grip the Follower Rod Handle and pull it until the Follower Rod is extended. Pull the Follower Rod sideways to latch it into the slot on
the end cap of the Grease Tube, locking it open.
3. Remove the Grease Tube from the Pump Housing.
4. Remove the plastic cap from a grease cartridge (not included), and insert the cartridge into the Grease Tube.
5. Remove the pull tab from the grease cartridge and screw the Grease Tube back into the Pump Housing.
Release Follower Rod from the slot on the end cap of the Grease Tube to allow the Follower Rod to move forward into the Grease Tube.
7. Once the Grease Gun is loaded, prime Gun and expel any air pockets as follows:
a. Close the Vent Valve.
b. Squeeze the Trigger several times to operate the Grease Gun until any trapped air is expelled and grease flows smoothly from the
Coupler.
c. Push the Follower Rod all the way into the Grease Tube. Gun is now primed and ready for use.
