Buell XB 2010, Руководство по обслуживанию

Страница: 259 / 714

2.53 TRIPLE TAIL: ULYSSES MODELS
GENERAL
See Figure 2-227 . The Triple Tail when folded forward acts as
a luggage rack (1) with integrated tie-down hooks. When in
the upright position, it is a passenger backrest (2) with subtle
flex for passenger comfort. When in the rearward position, you
can carry a passenger and have a luggage rack (3) for extra
carrying capacity (XB12X only).
1
3
2
4
4
4
4
om00592a
1. Forward luggage rack
2. Passenger backrest
3. Rearward luggage rack
4. Integrated tie down locations
Figure 2-227. Triple Tail: Ulysses Models
REMOVAL
NOTES
• The portion of the grab handle closest to the front of the
vehicle is slotted for easy access. The fastener does not
need to be fully removed.
• Before removing the Triple Tail, it will be necessary to
remove certain components of the luggage system. See
2.54 LUGGAGE: XB12XT .
1. Remove the seat.
2. See Figure 2-228 . To access fasteners (3, 11), remove
the plastic wire cover under the license plate light. Remove
the two screws and the two nuts to remove the plastic
cover.
3. Remove the right hand rear fastener (3).
4. Loosen but do not remove the right hand front fastener
(1).
5. Hold the triple tail rack (5) in place and remove the right
hand grab handle (2).
6. Slowly, slide the tail towards the right.
NOTE
The spring (6) in the left hand grab handle is held under ten-
sion.
7. Loosen but do not remove the left hand front fastener (12).
8. Remove rear fastener (11) and the left hand grab handle
(13).
DISASSEMBLY
1. See Figure 2-228 . Remove the fastener (9) and the plastic
collar (10) from the left hand grab handle (13).
2. To remove the bearings (4) from the grab handles, insert
a 3/4 in. blind bearing collet and extract.
3. Remove the pin (7) and detent (8).
4. Inspect and replace the spring, pin and detent as neces-
sary.
NOTE
Replace the bearing with a new bearing, if removed from the
grab handle.
ASSEMBLY
TOOL NAME PART NUMBER
SNAP-ON SEAL AND BUSHING
DRIVER A157C
1. Hold the right hand grab handle and using a SNAP-ON
SEAL AND BUSHING DRIVER (Part No. A157C), tap in
the bearing.
2. Hold the left hand grab handle to assemble the detent and
pin.
HOME
2010 XB Service: Chassis 2-179