Buell XB 2010, Руководство по обслуживанию

Страница: 260 / 714

3. Using a Snap-on seal and bushing driver, tap in the
bearing.
INSTALLATION
1. See Figure 2-228 . Apply LOCTITE 271 (red) to LH and
RH grab handle fasteners (1, 3, 11, 12).
2. Install the LH grab handle (13) unto the front fastener and
install the rear fastener. Do not tighten.
3. Slide the spring (6) into the LH grab handle (13).
4. Press the spring with the shaft of the triple tail rack and
hold the rack in place capturing the spring.
5. Install the plastic collar (10) and tighten the fastener to
36-48 in-lbs (4-5.4 Nm).
6. Holding the rack, fit the RH grab handle (2) unto the front
fastener and install the rear fastener. Do not tighten.
7. Tighten front and rear fasteners to the following specifica-
tions:
a. Tighten rear fasteners (3, 11) to 23-25 ft-lbs (31.2-
33.9 Nm).
b. Tighten front fasteners (1, 12) to 108-120 in-lbs (12.2-
13.6 Nm).
8. Verify that the rack operates properly.
9. Install the plastic wire cover under the license plate lamp.
Tighten the screws to 36-48 in-lbs (4-5.4 Nm) and tighten
the nuts to 12-36 in-lbs (1.4-4 Nm).
4
5
4
6
8
9
2
1
14
3
13
11
12
10
7
sm00693
8. 1. Detent, tail rack Front fastener, grab handle
2. 9. RH grab handle Screw, collar
10. 3. Collar, tail rack Rear fastener with washer, grab handle
4. 11. Bearing (2) Rear fastener with washer, grab handle
12. 5. Front fastener, grab handle Tail rack
6. 13. Spring LH grab handle
14. 7. Tail loop Pin
Figure 2-228. Triple Tail, Passenger Backrest and Luggage Rack: Ulysses
HOME
2-180 2010 XB Service: Chassis