Buell 2005 FIREBOLT, Руководство по обслуживанию

Страница: 157 / 621

2-96 2005 Buell Firebolt: Chassis
HOME
PASSENGER SEAT LOCK 2.39
REMOVAL
1. Remove rider and pillion seat. See 2.38 SEAT .
2. Remove upper body work on tail section. See 2.36 SUB-
FRAME TAIL ASSEMBLY AND BODY WORK .
3. See Figure 2-128. Disconnect passenger lock cable (9)
by removing cable from seat lock plate (6) and ferrule
from seat lock lever (4).
4. Remove seat lock lever (4) by removing fastener (2) and
washer (3) from seat lock (7).
5. Remove spring (5).
6. Remove seat lock clip (1) by sliding from seat lock plate
(6).
7. Remove seat lock plate (6) and seat lock (7).
INSTALLATION
1. See Figure 2-128. Install the seat lock (7) on to upper tail
body work.
2. Install seat lock plate (6) by aligning plate tab onto seat
lock (7).
3. Install seat lock clip (1) by sliding clip aligning clip groove
onto seat lock plate (6) tab.
4. Position short tab of spring (5) into seat lock notch.
5. Position long end of spring into the seat lock lever (4).
6. Load the spring (5) by turning the seat lock lever (4)
counterclockwise 1/4 turn.
7. Once the spring is loaded, install the seat lock lever (4)
onto the lock aligning the lever to the square groove that
is cast into the seat lock (7).
8. Fasten the lock lever (4) to the seat lock (7) with the
washer (3) and fastener (2).
9. Install the ferrule (8) of the seat lock cable (9) into the
seat lock lever (4).
10. Open and close the seat lock with ignition key to verify
that cable is working properly.
11. Install the seat lock cable (9) into the seat lock plate (6).
12. Install upper body work on tail section. See 2.36 SUB-
FRAME TAIL ASSEMBLY AND BODY WORK .
13. Install rider and pillion seat. See 2.38 SEAT .
Figure 2-128. Seat Lock and Cable Assembly
1. Seat lock clip
2. Fastener
3. Washer
4. Seat lock lever
5. Spring
6. Seat lock plate
7. Seat lock
8. Ferrule
9. Seat lock cable
b1011x2x
1
2
4
5
6
7
3
9
8