Boiler positioning
7
Logano GE515 - We reserve the right to make any changes due to technical modifications.
17
7.3
Positioning the boiler on a sub-
structure or on foundations
You can cast a concrete plinth if the optional boiler plinth
is not used. When casting the plinth, you must
incorporate a steel angle with the dimensions
100 x 50 x 8 mm or a steel strip with the dimensions
100 x 5 mm (
Æ
Fig. 7 and the following table), to ensure
the boiler sections will slide into position during
installation.
It is advantageous to position the boiler on a plinth
50 - 80 cm high (Fig. 7,
[1]
). The support surface must
be perfectly flat and level. The front edge of the boiler
should be flush with the edge of the foundation.
Fig. 7
Foundation dimensions in mm
1
USER NOTE
As accessory Buderus offers a boiler plinth
designed to reduce body resonance.
USER NOTE
z
When casting the foundation, note the
side to which the burner will be pivoted
(burner door hinged on the r.h. or l.h.
side, Fig. 6, page 16).
Number of
boiler sections
L
1
(foundation)
in mm
L
2
(length of
steel section)
in mm
7
1 360
1 190
8
1 530
1 360
9
1 700
1 530
10
1 870
1 700
11
2 040
1 870
12
2 210
2 040
