Operating the heating system
6
Logamax plus GB162-65/80/100 - Subject to modifications resulting from technical improvements!
18
6
Operating the heating system
6.1
Menu structure
You can navigate through the menu structure of the cen-
tral boiler on the BC10 using the "Reset" button, the
"Chimney sweep" button, the "Service button" (fig. 19,
items 1
,
2
and
3
) and the display (fig. 19
, item 4
) in
accordance with the menus in tables 5, 6 and 7.
6.1.1 Normal Operation menu
Information about the operating status of the boiler can
be displayed via this menu. The currently measured val-
ues of the CH (boiler) flow temperature (permanent indi-
cation), the working pressure and the operating codes
are shown. Proceed as follows:
fig. 19
BC10 basic controller
1
2
3
4
Normal operation menu
Step 1
[\/2/4|
Display value. Currently measured CH (boiler) flow temperature in °C.
Also see section 8.1, page 24.
Step 2
Continue in Normal operation menu?
Yes:
step
3
No:
step
1
Step 3
Press the
e
button.
Step 4
[p/1.6|
Display value. Currently measured system pressure in bar.
Also see section 8.1, page 24.
Step 5
Press the
e
button.
Step 6
[-/h/\|
Random display code. In this case: Operating phase: Boiler in heating mode.
Also see section 8.3, page 24.
Step 7
Have at least 5 seconds passed without a button being pressed and/or has the mains voltage
been interrupted ?
Yes:
step
1
No:
step
8
Step 8
Press the
e
button.
step
1
table 5 Normal operation
