Bucktool TDS-200C4HL, Инструкция по эксплуатации, Страница: 21 / 28

20
TDS-200C4HL
MAINTENANCE
6. Remove the hex nut (8), the outside
wheel flange (9) and the wheel (10)
as shown in Flg. K.
7. Inspect the wheel (10) for cracks, chips
or any other visible damage (other
than normal wear) and discard if such
damage is found. Inspect the blotter/
cardboard disc for damage. If the blotter
is missing or severely damaged, replace
it with a piece of thin cardboard or
blotter paper cut in the same shape.
NEVER USE A GRINDING WHEEL
WITHOUT A BLOTTER.
8. Install the new wheel and make
sure both wheel flanges (9)
are in place with the concave
sides toward wheels.
9. To prevent wheel rotating, place
a wood wedge (7) (not supplied)
between the wheel and the wheel
cover as shown in Fig. L.
10. Ti g h t e n t h e h e x nut (8) by an
adjustable wrench.
NOTE: Do not overtighten the nut as this can crack the grinding wheel.
11. Replace the wheel cover (6) and screws (4).
12. Reinstall and adjust the tool rest to 1/16 in. (1.6 mm) away from the wheel
and tighten securely.
13. Adjust the eye shield (1) to a point between your eyes and the wheel.
Fig.K
8
8
7
9
9
10
Fig.L
tighten