COSMY THE BOT |
100
|
150
|
200
|
250
| ROBOTIC POOL CLEANERS
COSMY THE BOT |
100
|
150
|
200
|
250
| ROBOTIC POOL CLEANERS
English
Troubleshooting
Warning
Do not stay in the pool and remove
any and all items from the pool before
operating the robotic pool cleaner. Do not
leave the robot inside the pool if unused.
The power supply must be connected
through a Ground Fault Current
Interrupter (GFCI USA) or a Residual
Current Device (RCD Europe) not
exceeding 30 mA.
The connection to the power must meet
local and national wiring rules.
All parts must be replaced with original
parts supplied by Aquatron Robotic
Technology.
Keep out of children's reach.
CLEANER DOES NOT TURN ON
There is no electricity in the wall socket:
(1) Disconnect cleaner from the power and control unit.
(2) Disconnect power supply from the wall socket, wait
30 seconds and reconnect. (3) Turn power on. If not
activated, connect the unit to a different wall socket.
Obstacle in the drive system of the cleaner unit:
(1)
Turn the cleaner unit carefully to view the underside.
(2) Check that the scrubbing brush is not bent/broken.
(3)Clean and remove obstacles and debris if neces-
sary.
Propeller is seized due to accumulation of hair:
Check if the propeller is broken or needs to be cleaned
(see “Checking Water Outlet Propeller”).
CLEANER MOVES BUT DOES NOT PUMP WATER
Filters are dirty:
(1) Remove the filters and clean
them.
Propeller is broken or seized due to accumula-
tion of hair:
Check if the propeller is broken or needs
cleaning (see “Checking Water Outlet Propeller”).
CLEANER PUMPS WATER BUT DOES NOT MOVE
Obstacle in the drive system of the cleaner unit:
(1) Turn the cleaner unit carefully to view the under-
side. (2) Check that the scrubbing brush is not bent/
broken. (3) Clean and remove obstacles and debris if
necessary.
CLEANER STARTS AND SHUTS OFF AFTER A
SHORT TIME
Filters are dirty:
(1) Remove and clean the filters. (2)
Restart the robot and try again.
Propeller is broken or seized due to accumulation
of hair:
(1) Remove the top screws on the top outlet.
(2) Check if the propeller is broken or needs to be
cleaned.
Obstacle in the drive system of the cleaner unit:
(1)
Turn the cleaner unit carefully to view the underside.
(2) Check that the scrubbing brush is not bent/broken.
(3) Clean and remove obstacles and debris if neces-
sary.
CLEANER DOES NOT PICK UP DIRT
Filters are dirty or have holes.
Clean as needed and verify that there are no holes in
the filters.
Propeller is broken or seized due to accumulation
of hair.
Check if the propeller is broken or needs cleaning (see
“Checking Water Outlet Propeller”).
CLEANER UNIT DOES NOT COVER THE ENTIRE
POOL
Clean the filters.
1. Verify that there is enough length of the floating
cable in the water to reach the far end of the pool.
2. Make sure that the floating cable is properly spread
out and is not tangled.
Propeller is broken or seized due to accumulation
of hair:
(1) Remove the top screws on the top outlet.
2. Check if the propeller is broken or needs cleaning.
THE CLEANER DOES NOT CLIMB WALLS
(1) Verify that your robotic cleaner is not a floor-only
model. (2) Verify that Program 1, floor cleaning only,
is selected on the power supply unit. (3) Make sure to
clean the filters (4) Make sure propeller isn't broken or
tied up to debris/hair.
6
