Worksurface Supports Must
Be Parallel to Worksurface
DIM A
DIM A
Steps 5 & 6
5
1
7
Dimensions "A" Must Be Equal
Steps 5-7 apply to worksurfaces with
no pilot holes.
Step 5:
Lay the worksurface
5
on a protected
surface. Place the left leg and hex rod
assembly on the worksurface at the location
shown at the left.
Step 6:
Place the right leg assembly
7
on the
worksurface. Insert the end of the hex rod
1
into the hex drive on the right leg assembly.
If it won't slide in, have an assistant lift up
slightly on the right leg assembly. This will
turn the hex rod. It should take less than 1/6th
of a turn to accomplish this. If you turn it more
than 1/6th of a turn, the legs will be at uneven
heights and the worksurface won't be level.
Step 7:
Square and align the worksurface
supports as shown in the bottom view and the
side view below. Attach the leg assembly to
the worksurface with (2) wood screws
6
.
Leave the wood screws loose by about 1/8"
until the cross support
16
is attached.
6
Back
3.250 Both
Worksurface
Supports
PAGE 4 OF 7
Bottom View
Side View
Step 7
Instruction # 52819
