[50]
[70]
[90]
222
311
400
Peel
Shear
[265]
[360]
[390]
1178
1601
1734
BD
+0,25
-0,00
6,3
6,7
6,9
[.250]
[.265]
[.275]
A (x2)
C.R.S.
0,6
0,75
1,0
mm
in
[.024]
[.030]
[.040]
A (x2)
BD
®
Joint Type: 4,6 [.18”]
mm
in
lbs
N
lbs
N
6.0 ToolInG
Tog-L-Loc tools are preset by BTM to give best joining results with a specific range of metal type and
thickness, as charted above. Higher strenths for a specific metal thickness may be obtained with
optimized tooling from BTM. All Tog-L-Loc/Lance-N-Loc tools are marked with numbers for easy
identification.
Tool ChanGe PRoCeDURe:
Please note: All tooling changes must be done with the press unit in the “open” position.
Removal of the air supply is required before the tool change or service begins.
Use a 2.5mm allen wrench to change the punch and die in the gun.
PUnCh ChanGe:
1. Remove the retaining screw with an allen wrench. Remove the punch from its pocket (It may be
necessary to pry with a wrench).
DIe ChanGe:
1. Remove the retaining screw with an allen wrench (It may be necessary to pry with a wrench).
2. When installing dies, care has to be taken so the springs are not damaged. Load the die on its
side, bottom first, then slide the bottom of the die toward the front of the gun carefully, so that the
springs do not bend. Note: If the springs are bent, the die does not function properly and the gun
will form inferior joints.
bUTTon aDJUsTMenT:
Adjustment is achieved by increasing the air pressure to increase button size. Decreasing air pressure
decreases button size. Make tests joints until the desired button dimension is achieved.
Tool
In
G
