3
ST-00000220-
24/04/2019
K4659
EN
The device can be configured using the MyHOME_Up app with firmware versions after 2.1 and with app versions after 2.2 (for the use see the relevant documentation).
As an alternative, it is also possible to use the MyHOME_Suite configuration software (version after 03.03.73), or physical configurators connected to the appropriate sockets.
2. MyHOME system
When installed in a Lighting Management system, the device can be configured in the following ways:
- Plug & Go: automatic procedure for pairing devices connected to the inputs and outputs. The procedure is activated on powering the device. It is only available for Room Controllers or,
in the case of other devices, paired with the Room Controllers.
- Push & Learn: procedure for pairing different connected devices or changing the assignments defined automatically in the Plug & Go procedure. For more details, please refer to the
specific document.
- Software Configuration: using the Virtual Configurator software; for more details, please refer to the specific manual.
1. Lighting Management System
Modification of the parameters using the configuration remote controls
Configuration
Volume coverage
8 m (PIR)
5 m (PIR)
3 m
(PIR)
≈ 6 m
(PIR)
1,2 m
m
6
4
5
8
Small movements
Large movements
For further configurations use the remote control item BMS04001 – BMS04003,
see www.legrandoc.com
ON/OFF Auto function (factory setting)
The sensor parameters are defined by 6 configurator sockets and the functions depend on the operating mode:
Local: A = 1 – 9
Light point: PL = 1 – 9
Mode: M = 0 – 4
Sensitivity of the PIR movement sensor: S = 0 – 3
Control timer: T = 0 – 9
Sensitivity of the lights sensor: D = 0 – 5
Warning: the addresses A = 0 and PL = 0 do not exist
3. Physical configuration
•
BMSO4001
: advanced configuration remote control
•
BMSO4003
: simplified configuration remote control
When the sensor receives an IR command from a configuration remote control, it
beeps to confirm that the modification has been acquired.
For more information on the parameters please refer to the technical info sheet of the
remote control BMSO4001.
Return to factory settings:
1st press: Briefly press LEARN, the LED will blink slowly.
2nd press: Press and hold LEARN for 10 seconds until the LED flashes quickly.
PIR flush mounting motion sensor