BTI 4.3 TFT, Руководство по установке

Страница: 58 / 60

58
Display ECU Warnings: This setting will allow the screen to
display warnings generated by some ECUs. Note that not all
ECUs generate warnings.
Display User Warnings: This setting allows the user to
determine warning thresholds for the parameters pictured to the
left. Touch the parameter to set the value. (Note that these
values are absolute and to not convert when switching units so
be sure to have your desired units selected before setting these
values.) Tire pressure warnings only work when using a CAN
TPMS.
In the event that a user warning does trigger, the warning will be
display and the parameter highlighted. The warning may be
cleared which will cause the display to resume normal operation.
There is a warning counter that will re-trigger for a condition that
may have been cleared and corrected but the error has
reoccurred.
TRAC and BOOST PWM Steps:
Use these two buttons to configure how many steps are to be
programmed in the Infinity Tuner software for Boost and Slip.
Typically the scale is from 0-5 volts and the max amount of
steps allowed is 10 which give you 11 settings (0-10).
Example: a value of 10 here would make each step would have
a value of .5 volts. A value of 1 here would give the step a
value of 5 volts. It is
imperative to view each step in the
software when configuring this as there could be a potential
difference with regard to ground.
** Note that these two settings should be configured by competent personnel. Raising the BOOST too much or reducing
the SLIP too much can have severe consequences. **
Analog outputs:
Use this screen to out a 0-5v analog output on the Blue and
Brown analog output wires from the display. These output
voltages are directly tied to the PWM steps mentioned above.
Most of the newer ECUs will allow these changes over the
CAN bus, but older ECUs like ECU Master Classic, AEM V2,
and AEM Infinity are limited to using these analog outputs tied
to the ECU analog inputs.