Edition 5
10 March ‘99
Using the
answering machine
10
Setting the volume
To set the playback volume
The volume increases/decreases
a step every time you press the volume button.
This is indicated by a short beep.
When you reach the loudest or quietest setting
you will hear two beeps.
•
Press the
+
button to increase the
playback volume.
•
Press the
-
button to decrease
the playback volume.
The volume of your outgoing message is not
affected by changing the playback setting.
Always make sure that the volume is at a level at
which you can easily hear your messages.
- +
Adjusting the number of rings
before a call is answered
When the answering machine is switched on,
you can set the number of times your Response
130 will ring before it answers a call.
To set the answer delay
The
ANSWER DELAY
switch, which is located
on the underside of the base, can be set to
2
,
6
or
TS
(time saver), by moving the switch one
step at a time.
• The
2
rings setting will be answered after
about 4 - 5 seconds. Your Response 130 is
preset to this position.
• The
6
rings setting will be answered after
about 17 seconds.
• The time will vary, dependant on which
exchange or switch the Response 130 is
connected to.
• The
TS
setting (time saver) can save you
time when accessing your machine remotely.
Your Response 130 answers after 2 rings if
you have any messages or 6 rings if there
are none. When you call to listen to your
messages, if the telephone rings a third time
it means there are no messages, so hang up
to save time.
ANSWER
DELAY
TS
6
2
