UDR-103 BP WWW.BSTDJ.COM
© Copyright LOTRONIC 2012
Page 9
DESCRIPTION OF RECEIVER
1) ANTENNA
Please connect on these sockets the two provided antennas
2) UP
BUTTON
Use to adjust frequency or parameters
3) DOWN
BUTTON
4)
Use to adjust frequency or parameters
5) MENU
BUTTON
Use to enter in menu functions
6) INFRARED
SENSOR
Use to transmit frequency to transmitter
7) POWER
SWITCH
Press and hold on to switch on
Press and hold on to switch off
8) VOL-
BUTTON
Use to decrease output level
9) VOL+
BUTTON
Use to increase output level
10) UNBALANCED
OUTPUT
This output is the main output of the receiver. You must to connect it to an input of a mixer or directly to a power amplifier.
Note : This output is an unbalanced output. Use a Jack 6.35mm cable
11) POWER SUPPLY SOCKET
Connect the external power supply provided with the set ( DC 12V )
Note : Don’t connect an another kind of power supply on this socket ( AC or DC upper to 12V ) either you can destruct the receiver
12) BALANCED
OUTPUT
This output is the main output of the receiver. You must to connect it to an input of a mixer or directly to a power amplifier.
Note : This output is a balanced output. Use a XLR cable
13) SQUELSH
SETUP
This control is set in factory. If you have a lot of interferences, please adjust this rotary control
RECEIVER STARTUP
-
Install the two antennas
-
Orient them at 90 ° to the receiver
-
Connect the external power supply
-
Push the power switch during 2 or 3s
-
Set the frequency in using Up and Down buttons
-
To switch the receiver off, push the power switch during 2 or 3s
