14/25
Figure 6
3.3 Rotor linker and Rotor Assembly
Before assembling the hub and rotor refer to
Figure 7
below, and the following
detailed instructions.
Assembly with the screws and spring washers
NOTE:
To avoid damage to the blades during installation, do not put the blade/hub
assembly on the turbine until the turbine is mounted on the tower.
Blades linker direction:copper washer to blades
Figure 7
3.3.1 Mounting the Blades
CAUTION:
THE EDGES OF THE ROTOR BLADES ARE SHARP.
PLEASE HANDLE WITH CARE.
Notice that the screw holes in the blades are counter-bored for the socket head cap
screws. Place one of the blades with the counter bore facing up, and align the screw
holes. Insert one of the socket head cap screws with washers through the blades and
hub.
Repeat this procedure on all three blades. Do not over-torque.
Please note that over-torque of blades may cause damage to the blade and
compromise the safety of the product.
A: Assembling the rotor blades and the blades protection plate.
