1. Put the pallet in a convenient position with a forklift.
2. Remove all packaging materials.
3. Remove the pump from its pallet with suitable lifting equipment.
•
Attach the lifting equipment to the lifting bolts of the pump.
•
The center of mass of the pump is offset towards the motor. Additional support belt
must be installed on the motor to ensure that the pump is supported during lifting to
prevent it from tilting.
4. Remove all protective covers and inspect the pump.
5. If the pump is damaged, notify the supplier and the carrier in writing within three days,
indicating the part number of the pump and the order number and the supplier invoice
number. In addition, all packaging materials must be kept for inspection. Do not use the
pump if it is damaged.
6. If the pump is not intended to be used immediately, reinstall the protective covers. And
store the pump in the conditions as described in sections 2.1 and 6.1.
3.4 Oil filling
WARNING
Ensure that the oil grade used is correct and the oil levels in the pump are
correct. If the oil is used improperly or the oil level is incorrect, the
performance of the pump will be affected and the pump may be damaged,
which will endanger its structural safety.
3.4.1 Hydraulic drive
We recommend that the oil level on the motor side cover be maintained at the recommended
oil level shown in Figure3. If the oil level above or below the recommended oil level, the
performance of the pump may be affected.
The oil level must not be lower than the bottom of the reflector plate(Figure 3), otherwise the
pump will be damaged. Proceed as follows:
1. Unscrew the oil filler plug (See Fig.2).
2. Filling the pump oil to the recommended oil level is at the top of the motor side cover
reflector plate (See Fig. 3).
Due to the internal structure of the motor side cover, refueling to the top of the reflector
plate, the oil level in the oil level sight glass of the motor side cover will slowly drop.
Observe for a while, when the oil level is no longer falling; continue to refuel to the top
of the reflector plate. Observe for a while, if the oil level is still below the top of the
