12.
Then, drill a hole with the Ø 3.2 mm drill bit into the fixed profile of the
pivoting side (4) and the fixed profile (17), both at top and bottom. Use the
rubber washers and ST4x10 screws (13) to fix them in place. Press the
screw caps over the screws, as shown in figure 10 and 11. Connect the
profile of the side panel (20) in the same way to the wall profile (21), as
shown in figure 10 and 11.
Ø 3.2
13
14
Hol e: ¦ Õ
3. 2
M4X10 scr ew
13
Ø 3.2
Figure 10
Figure 11
13.
Attach the horizontal anti-water strip (16) to the bottom of the pivot door
(11), press the horizontal decorative strips (2) into the rail profile (1), both
at top and bottom as shown in figure 12.
anti-water plastic strips
decor at ed
strips
anti-water plastic strips
3
16
14
Figure 12
Figure 13
14.
Attach the vertical anti-water strips (3) to both sides of the door (11) as
shown in figure 13.
15.
Finally, at all points connected to the wall, shower tray/ floor and the
profiles, use silicone sealant only on the outside of the cubicle.