Brutus 61024BR, Руководство пользователя

Страница: 4 / 48

– 2 –
Drip loop
FIGURE 1
WARNING
PERSONAL INJURY CAN OCCUR IF OPERATED
IMPROPERLY.
• Keep fingers and loose clothing away from rotating
blade.
• Use extreme caution when cutting tile. Make sure
hands and fingers are clear from the blade groove in
the sliding table. Severe abrasion, cuts, or pinching of
hands or fingers can occur as the table is advanced,
particularly at the end of its travel.
• Electrical shock can occur if operating instructions
are not followed.
FOR YOUR OWN SAFETY READ INSTRUCTION
MANUAL BEFORE OPERATING SAW.
• Wear eye protection.
• Use blade guard for every operation for which it can
be used.
• Unplug saw before servicing, when changing cutting
wheels, and cleaning.
• Use tool only with smooth-edge cutting wheels free
of openings and grooves.
• Replace damaged blades before operating.
• Do not expose to rain or use in damp locations.
• Do not fill water tray above water fill line.
16. USE RECOMMENDED ACCESSORIES.
Consult the
owner’s manual for recommended accessories.
The use of improper accessories may increase risk
of injury.
17. NEVER STAND ON TOOL.
Serious injury could
occur if the tool is tipped or if the cutting tool is
unintentionally contacted.
18. CHECK DAMAGED PARTS.
Before further use of
the tool, a guard or other part that is damaged
should be carefully checked to determine that
it will operate properly and perform its intended
function – check for alignment of moving parts,
binding of moving parts, breakage of parts,
mounting, and any other conditions that may
affect its operation. A guard or other parts that are
damaged should be properly repaired or replaced.
19. DIRECTION OF FEED. Feed work into a blade
against the direction of rotation of the blade only.
20. NEVER LEAVE THE TOOL RUNNING
UNATTENDED. TURN POWER OFF. Do not leave
tool until it comes to a complete stop.
21. ALWAYS TURN OFF THE POWER
while adjusting
the angle for miter cuts.
22. CUTTING TABLE MUST BE IN THE STARTING
POSITION
before adjusting the cutting head, to
perform bevel cuts.
23. ENSURE THAT THERE IS A CONTINUOUS FLOW
OF WATER
to both sides of the blade during
operation.
24. CHECK DIAMOND BLADES CAREFULLY FOR
CRACKS, NICKS, MISSING DIAMOND MATRIX
OR OUT OF ALIGNMENT CONDITION.
Replace
damaged blades immediately. Do not use
damaged blades, which can cause bodily injury.
POSITIONING OF TILE SAW
A. To avoid the possibility of the appliance plug or
receptacle getting wet, position the tile saw to one side
of a wall-mounted receptacle to prevent water from
dripping onto the receptacle or plug. The user should
arrange a “drip loop” is that part of the cord below the
level of the receptacle, or connector if an extension
cord is used, to prevent water traveling along the cord
and coming in contact with the receptacle (FIGURE 1).
B. If the plug or receptacle does get wet, DO NOT
unplug the cord. Disconnect the fuse or circuit breaker
that supplies power to the tool. Then, unplug and
examine for presence of water in the receptacle.