Brush Bandit 65XL, Инструкция по эксплуатации и каталог запасных частей

Страница: 45 / 149

Bandit
Copyright 1/10 PAGE
MODELS 65XP(XL)/95 MAINTENANCE SECTION
YEARLY MAINTENANCE
1) Hydraulic oil:
Change hydraulic oil and flush the hydraulic reservoir
tank.
2) Hydraulic suction screen(s):
Change hydraulic suction screen(s) yearly or every
000 hours.
3 MONTH MAINTENANCE
1) Hydraulic oil filter(s):
Must be replaced after FIRST 10 HOURS OF
OPERATION, USE A 10 MICRON FILTER. After
first change replace oil filter every 3 months or 400
hours.
2) Grease discharge swivel plates:
Grease swivel plates for discharge as needed.
3) High pressure oil filter(s) (if equipped):
Must be replaced after FIRST 10 HOURS OF
OPERATION. After first change replace oil filter every
months or 00 hours.
MONTHLY MAINTENANCE
1) Check towing hitch:
Check for excessive damage or wear. Replace if
needed. Keep pintle ring greased to reduce wear.
2) Check discharge and infeed hopper wear:
Check for wear on discharge, infeed hopper, and
discharge direction adjustor; build up, repair or replace
as needed.
3) Inspect feedwheel motor connections:
Check and maintain correct torque, on feedwheel
motor connections. See page .
4) Check feedwheel teeth for sharpness:
Replace if needed.
5) Check chipper bearings and chipper sheave:
Check, retighten all bearing bolts, bearing lock collars,
and also belt sheave bushings to correct torques.
6) Check hydraulic function pressures:
Check, reset and maintain all hydraulic function
pressure settings to a maximum of the specified PSI
(bar). This will give you the best performance from the
hydraulic system.
7) Tire air pressure:
Fill each tire to rated capacity on tire.
8) Check wheel bearings:
Check and grease or oil wheel bearings per axle
manufacturer’s instructions.
9) Check and adjust brakes (if equipped):
Check and adjust brakes as needed per axle MFG.
manual.
10) Check discharge chain tension (if equipped):
Check tension on hydraulic or hand crank swivel
dicharge chain drive and tighten as necessary. Chain
tension is 1/” (6 mm) per foot (0. m) of center
distance between the sprockets, NOT to exceed a 1/2”
(13 mm) of deflection. Do not over tighten, which may
result in hydraulic motor failure.
11) Lubricate “Bandit” lever throttle cable:
If the machine is equipped with a “Bandit” lever throttle
system, lubricate inner throttle cable and cable ends
with a cable lube or SAE 10W/0 oil. Replace throttle
cable if it doesn’t operate smoothly.
12) Check chip box turntable bearing (if equipped):
Check and retorque the chip box turntable bearing
bolts.