Brush Bandit 2900T, Инструкция по эксплуатации и каталог запасных частей

Страница: 26 / 94

Bandit
Copyright 1/07 PAGE 22
MODEL 2900T TRANSPORTATION PROCEDURES
BEFORE LOADING OR UNLOADING THE MACHINE INSPECT AND CONFIRM THE
FOLLOWING STEPS:
When loading or unloading the self-propelled stump grinder on the trailer, use care
and caution. The maneuvering of the equipment must be slow, smooth, and intentional, not fast and jerky.
Loading & Unloading
1) Make sure the trailer and towing vehicle are parked on a flat surface. They must be stable on the
surface with the brakes locked and/or the wheels choked to avoid unwanted movement
2) Position the loading ramps or loading gate securely between the trailer and the ground level. Have them
located so that they are in line with the tires or tracks of the stump grinder when it moves.
3) Remove and store the chains and binders used for transporting.
4) Confirm that there are not any obstacles on the trailer bed, around the trailer that may cause restricted
movement of the stump grinder or the operator.
5) The only person in the area should be the one that is operating the stump grinder controls, and he/she
should be very experienced with the controls on this stump grinder
6) If you are on streets, roads or public areas, position the warning cones etc, per your company’s safety
policies.
7) Follow all pre-startup instructions for the machine.
8) Once the engine is running at as low a speed as possible, carefully raise the cutterwheel slightly up off
the ground or trailer bed. While loading or unloading the stump grinder, the cutterwheel should not be
raised any higher than necessary to just clear whatever is under it. You need to keep the weight center
of gravity as low as possible to avoid tipping the machine while it is moving.
9) The cutterwheel end of the stump grinder should always be positioned so that it is toward the rear of the
trailer, not the tongue, during transport.
10) When the stump grinder is positioned on the trailer bed, there should be about 15% of the stump grinder
package weight on the tongue or hitch.
11) Align the stump grinder with the trailer bed, and the loading ramps. The only equipment movement
should be slowly, straight on or straight off the trailer.
12) With the engine and the stump grinder at as low a speed as possible, move the machine toward the
ramp system. Make sure the alignment is correct throughout the travel, and carefully readjust the cutter
wheel height so that it barely clears obstacles as it is going up or down the ramp system.
13) Properly secure the equipment and the area to avoid any possible accidents or dangers.
14) The trailer should be constructed with appropriate chain down positions for the specific sized stump
grinder. You must have binders that will withstand the strain of the machine trying to move while it is
being transported.
15) The loading ramps or loading gate of the trailer must be constructed to withstand the weight and forces
involved in loading and unloading the stump grinder.
WARNING