Brunton Outback, Руководство по эксплуатации

Страница: 14 / 21

23 24
E
RASING
B
EARINGS
1) The Outback must be in Bearing mode to erase bearings.
2) If erasing one bearing press ADVANCE until that memory position is
shown in the display word. (Example: Òb1 110¡Ó) This bearing can be
reprogrammed over by pressing ENTER while lining up a new bearing, or it
can be erased completely.
3) If erasing all stored bearings, it is not necessary to press ADVANCE repeatedly.
(see step 6)
4) To erase one or all bearings completely, hold MENU until PROGRAM
flashes to enter programming mode. The display word flashes ÒERASE.Ó
The Outback is in operating mode of Bearing. The current
heading is 192¡, and the heading reference is magnetic north.
The display word shows the stored bearing of 110¡. The solid
arrow points North and the flashing arrow points to the stored
bearing direction of 110¡.
MULTILEG
MAG
TIMER
CLOCK
DECLIN
DAMPING
TRL BLZR
BASIC
BEARING
F
IGURE
6
B
EARING
M
ENU
O
PTION
The Outback must be in Bearing to use any of the features described in this section.
F
EATURES
Bearing mode takes and stores up to 10 bearings (headings) in memory, b0
through b9. For example, you can store the bearings to a mountain on the horizon
and to a nearby windmill. With two bearings and a map of the area, you can find
your position by triangulation. The more bearings used, the more accurately you
can pinpoint your location on the map.
In Bearing, the Outback can be used as a compass as well as to store
bearings: the Numeric Display shows the current heading, a solid arrow on the
compass rose points to North, a flashing arrow on the compass rose points in the
stored bearing direction, and the display word shows the stored bearing.
S
TORING AND
V
IEWING
B
EARINGS
1) The Outback must be in Bearing to store or view bearings.
2) Press ADVANCE to step from one stored bearing to the next, until the memory
position where you want to store bearing is in the display word.
3) Bearings can be stored in any memory position, whether there is a bearing
previously stored or not. The Outback allows you to view all programmed
and unprogrammed memory positions, b0 through b9.
4) Point the Outback in the direction you want to store, line up the gunsights
and press ENTER.
5) A flashing arrow on the compass rose points in the direction of the stored
bearing and a solid arrow points North. The display word shows the stored
bearing (Example: Òb1 110¡Ó), and the numeric display shows the current
heading. See Figure 6 on the next page.
6) To store another bearing repeat steps 1 through 4.
NOTE: Pressing ENTER while viewing a stored bearing will erase that stored bearing and store a new one.
Take care not to accidentally erase a stored bearing.
BRUNTON MAN. MECH. 7/97 9/29/98 9:09 AM Page 14