INSTALLATION INSTRUCTIONS
FOR BRUNETTI TOILET SUITES
Before installation, a visual check of the suite should
be undertaken. The pan, seat, pan fixings and trap
connector come in one box and the cistern and valves
are in a separate box. Ensure that nothing is damaged
or missing.
The drawings on the back of this installation document
show the “set-out’ for the Brunetti pan. If it is to be
installed as an S-trap, the standard set-out can be
anywhere from 90-155mm (Back To Wall models) &
90-105mm (Wall Faced with Concealed Cistern Models)
from the finished wall to the centre of the waste outlet.
The two-piece plastic trap connector allows additional
flexibility in the set-out if needed.
Brunetti toilet suites can be installed
with back-entry water connections.
The Brunetti pans can be installed as
P-trap, or S-trap using the universal
plastic trap connector supplied with
the pan.
1.
Establish the rough in positions for the water inlet
to the cistern, the waste outlet and the holes for
the pan fixing brackets (see drawing overleaf).
For back-inlet connections, ensure the water
inlet connection is extending 40mm from the
finished wall.
2.
Prepare the waste outlet according to the required
set-out.
For S-Trap installations, cut the plastic trap
connector to suit the set-out. (The grooves on the
trap connector are 10mm apart.)
For P-Trap installations, set the centre of the
waste outlet 185mm from the finished floor level.
NB. A pan collar to connect the P-trap to the
waste outlet is not supplied with the pan.
3.
Drill the holes in the floor for the fixing brackets,
ensuring that they are 40mm inside the traced
outline of the pan (see separate instructions
accompanying the bracket).
The installation of this toilet suite should be undertaken by a qualified and licensed plumber and in accordance with the
National Plumbing Code AS/NZS 3500.2 Harmony sanitaryware products are designed to meet the appropriate Australian standards.
BRUNETTI
SETUP:
For further information, visit
www.harmonybathroomware.com.au
