BRULA BRULA NEO, Инструкция по установке и обслуживанию

Страница: 20 / 52

BRULA NEO service instructions Dated 03/18 Page 20 of 52
4 Startup
At the factory, the BRULA NEO combustion control system is pre-set to the
respective fireplace if ordered at the same time. Failing this, the control system
must be adapted to suit the fireplace which involves it being configured
appropriately.
The following tasks must be completed before the BRULA NEO can enter
service:
1. Fireplace must be installed properly and connected to the chimney. Inlet
airways must not be angled or sealed.
2. On appliances with circulating water: Appliance must be filled, bled and
properly connected to the water supply. Accumulator charge pump
installed. The thermal drainage safety device must also be connected
up.
3. Flue gas sensor fitted on the fireplace insert.
4. Flue gas sensor and throttle valve connected to the control
5. If the accumulator charge pump is to be activated by the BRULA NEO,
a PT1000 sensor must be placed in the fireplace insert and another
PT1000 sensor must be placed above in the buffer storage unit and
both connected to the control system, at PT1 or PT2. In addition, relay
1 must be set to the "Differential thermostat" function. The cable to the
pump must be fitted with a cable housing, and must be connected to
the "Pump out" bushing. Details of this can be found in chapter 10
"Relay functions / Pump connection"
Now the self test can be carried out.
At the start of combustion, the BRULA NEO MUST be activated by
pressing the screen so that the throttle valve opens.
For this the screensaver must already be active, i.e., in the case of doubt
wait a little (max. 2 minutes) until the screensaver is active. With the air
slider on the main menu of the display, 100 MUST be shown as otherwise
a fire cannot be ignited.