BRP SEA-DOO Search and Rescue Series 2017, Руководство оператора

Страница: 53 / 164

INFORMATION CENTER (GAUGES)
VTS Mode
The VTS MODE function is used to
manually set the VTS or change VTS
PRESET settings.
Refer to
OPERATING INSTRUCTIONS
subsection for detailed instructions.
Display
The DISPLAY function is used to
change the indication in the numerical
display. Refer to
CHANGING NUMER-
ICAL DISPLAY INDICATION
.
Fault Codes
The FAULT CODES function is used to
display active fault codes.
Refer to
MONITORING SYSTEM
sub-
section for details.
Settings
The SETTINGS function is used for:
– Changing the clock setting, refer to
MULTIFUNCTION GAUGE SETUP
.
– Activating the iBR override function,
refer to
SPECIAL PROCEDURES
.
Changing Numerical
Display Indication
To change the indication in the numeri-
cal display, carry out the following:
1. Press the MODE button on the RH
handlebar repeatedly until DISPLAY
is visible in the multifunction display.
MESSAGE DISPLAYED
DISPLAY
2. Press the SET button to enter the
DISPLAY function.
3. Press the UP/DOWN button until
the preferred indication is visible in
the multifunction display (as appli-
cable to model).
– RPM
– SPEED
– CLOCK
– ENGINE TEMP
– TOP SPEED
– AVG SPEED
– TOP RPM
– AVG RPM.
1
2
NUMERICAL DISPLAY SELECTION
1. Type of selected numerical display
indication
2. Applicable value
4. Press the SET button to select and
save the preferred indication, or
wait for the display function to time
out. The last indication visible will
be automatically saved.
Resetting Numerical
Display Indication
The following numerical display indica-
tions can be reset when selected:
– Average fuel consumption
– Top speed
– Average speed
– Top RPM
– Average RPM.
To reset the indication. double click the
SET button. The numerical display will
momentarily indicate zero (0).
_______________
51
https://www.boat-manuals.com/