BRP SEA-DOO ADVANCED TEC 2010, Руководство пользователя

Страница: 26 / 63

LAUNCHING THE WATERCRAFT
10. Unlock the iCatch mechanism by
pulling lever out and turning clock-
wise.
smo2010-005-004_a
Step 1: Pull lever out
Step 2: Turn clockwise
NOTE: Always make sure that the
iCatch system is unlocked before at-
tempting to unload the PWC.
11. Take place on the watercraft.
12. Put your personal flotation device
(PFD) on and attach the safety lan-
yard to it.
13. Get watercraft ready for engine
starting but do not start engine
yet.
14. Pull the iCatch release handle up.
Handle will stay up indicating that
the iCatch is ready for further load-
ing.
smo2010-003-010_a
PULL HANDLE UP
15. Once the watercraft has rolled off
the trailer, start engine.
NOTICE
Rocks, sand or other de-
bris will be sucked into the water-
craft propulsion system if engine is
operated using too much throttle in
shallow water.
16. Moor the watercraft.
17. Drive the tow vehicle out of the
ramp.
18. Install taillights on trailer.
19. Connect taillights connector.
Launching the Watercraft
(ADVANCED TEC)
NOTICE
Taillights are not sub-
mersible, before launching or load-
ing, always remove taillights.
1. Prepare the personal watercraft
(PWC) for launching according to
the PWC manufacturer's recom-
mendations.
2. Remove tie-downs from stern and
trailer eyelets.
3. Disconnect taillight connector as
follows:
3.1 Rotate connector counter-
clockwise.
3.2 Pull connector out of the
mounting plate.
smo2010-004-400_a
4. Unscrew both locking devices.
24
______________
https://www.boat-manuals.com/