BRP Lynx Rave 600RS 2020, Руководство оператора

Страница: 125 / 188

MAINTENANCE PROCEDURES
WARNING
To prevent serious injury to individuals near the snowmobile:
– NEVER stand behind or near a moving track.
– Always use a wide-base snowmobile stand with a rear de-
flector panel if it is necessary to rotate track.
– When the track is raised off the ground, only run it at the
lowest possible speed.
Centrifugal force could cause debris, damaged or loose studs,
pieces of torn track, or an entire severed track to be violently
thrown backwards out of the tunnel with tremendous force,
possibly resulting in the loss of a leg or other serious injury.
Track Tension Verification
NOTE: Ride the snowmobile in snow about 15 to 20 minutes prior to
adjusting track tension.
1. Remove tether cord cap from engine cut-off switch.
2. Lift rear of vehicle and support it off the ground.
CAUTION Use proper lifting techniques, notably by using
the force of your legs. Do not attempt to lift the rear of vehicle if
it is above your limits.
3. Allow rear suspension to fully extend.
4. Use the tensiometer.
REQUIRED TOOL
TENSIOMETER (P/N 414
348 200)
5. Set deflection between 30 mm and 35 mm
(1-3/16 in and 1-3/8 in) using bottom O-ring.
_________________
123