BRP I-Command Evinrude Etec Series, Руководство пользователя

Страница: 88 / 113

86
Gauge Flashes Four Dashes
1. If the I-Command digital display flashes four dashes (– – – –) it indicates
the gauge is not receiving signal from one or more devices.
2. A Network Test Kit, P/N 765023 is available to assist in troubleshooting
network problems. If desired, order the tester kit through your dealer.
Troubleshoot network problems using process of elimination.
•Make sure devices are configured. See “Advanced Setup and Opera-
tion” on page 57.
•If multiple displays are flashing, check common items such as cables
and tees.
•Remove components from the network
one at a time to isolate which
one may have failed.
•Look for damaged parts. Check connectors for corrosion.
•Swap known good components (sensor, cables or tees) to isolate the
faulty component.
•Reconnect the good component to the network and the remove the next
one in line.
•Continue this process for each device, cable or tee connector on the
network until the faulty part is found.
Note: Once components are reconnected, if the digital display continues to
flash, turn power to the network OFF and back ON to reset the gauge(s).
M E N U
DOWN
UP
EXIT
PAGES
ENTER
WTR: T
ALR:V BATT:V
WTR:P
Volts Volts
°F psi
– – – – – – – –
13.6 56.2
20 70
10 35
0 0
20 70
10 35
0 0
x10
+ + -
- -
+ +
L
L
L H
H H
S
+
N2K Bus
Tester
DEVICED
E
V
IC
E
BUSS BUSS
1
2