BRP E250DHLSCS, Руководство по обслуживанию

Страница: 198 / 396

196
OILING SYSTEM
OILING SYSTEM TESTS
Oil Injection Pump Circuit
Resistance Test
IMPORTANT:
The complete oil injection pump
electrical circuit includes
EMM
alternator output,
the engine wire harness, the injection pump wind-
ing and connectors, and the oil injector control cir-
cuit of the
EMM
. Check continuity of all wiring and
connections.
Disconnect the battery cables at the battery.
Use an appropriate test probe to make a connec-
tion to pin 1 of the oil injection pump connector.
Calibrate ohmmeter to the LOW OHMS scale and
measure the resistance between pin 23 of the
EMM
J1-B connector and pin 1 of oil injection
pump connector.
•
An infinite reading (
∞
) indicates an open circuit.
Isolate the faulty wiring, connection, or injection
pump winding. Repair faulty wiring or replace
faulty component and retest.
•
For a higher than expected reading, test resis-
tance of the injection pump. If injection pump
resistance reading is approximately 2-3
Ω
,
injection pump winding is good. Isolate faulty
component. Repair faulty wiring or replace
faulty component and retest.
Oil Supply Vacuum Test
Remove the oil pick-up assembly from the oil
tank.
Carefully remove the pickup filter and flush with a
mild solvent to remove any contamination. Rein-
stall filter.
Carefully remove the oil hose from the oil pickup
and remove the oil supply hose from the oil injec-
tion pump.
Use low pressure air to purge oil from hose.
Use Plug/Holder, P/N 329661, and clamp to plug
the pickup end of the hose.
Oil Injection Pump Circuit Resistance
2 to 3 Ω
1.
EMM
J1-B connector (pin 23)
2. Oil injection pump connector (pin 1)
004343
1
2
WARNING
Wear safety glasses to avoid personal
injury, and set compressed air pressure to
less than 25 psi (172 kPa).
1. Oil hose
2. Oil pickup
3. Low pressure air
12306
1. Plug/holder
2. Oil hose
12307
3
1
2
2
1