S-1110A
6. PREPARATION BEFORE SEWING
9
6. PREPARATION BEFORE SEWING
6-1. Installing the needle
CAUTION
Turn off the power switch before installing the needle.
The motor will keep turning even after the power is switched off as a result of the motor’s inertia. Wait until the
motor stops fully before starting work.
The machine may operate if the treadle is depressed by mistake, which could result in injury.
1. Turn the machine pulley to move the needle bar (1) to its
highest position.
2. Loosen the screw (2).
3. Insert the needle (3) in a straight line as far as it will go,
making sure that the long groove on the needle is at the
left, and then securely tighten the screw (2).
6-2. Removing the bobbin case
CAUTION
Turn off the power switch before removing the bobbin case.
The motor will keep turning even after the power is switched off as a result of the motor’s inertia. Wait until the
motor stops fully before starting work.
The machine may operate if the treadle is depressed by mistake, which could result in injury.
1. Turn the machine pulley to raise the needle until it is
above the needle plate.
2. Pull the latch (1) of the bobbin case upward and then
remove the bobbin case.
3. The bobbin (2) will come out when the latch (1) is
released.
0795M
0798M
Front
Long
groove
2119M
For thick materials
2120M
3848M
