Brother P-Touch PT-2730, Руководство по обслуживанию

Страница: 68 / 105

III - 48
3.2 Final Check and Inspection Mode
■
After completion of reassembling
(1) Check that each rubber key works correctly with light touch.
(2) To memory, press the [ON/OFF] key with both the [Space] and [BS] keys held
down. When releasing those keys, be sure to release the [ON/OFF] key first and
then release the [Space] and [BS] keys. Then press the [ON/OFF] key to turn
the machine off.
■ Make operational checks of machine in the inspection mode
The inspection mode allows you to write the setting to the machine and make final
operational checks. In this mode, you use seven submodes--WRITE SETTING,
CASSETTE, KEY, PRINT1, CUT, ENCODER and WRITE SERIAL NO. submodes.
TIP: The inspection mode actually supports a total of 16 submodes for checking at
the factory. If any submode other than the above seven is initiated, skip it by
pressing the
1 , 3 , 4 , 5 , 6 , E , or U key to proceed to the WRITE SETTING,
CASSETTE, KEY, PRINT1, CUT, ENCODER, or WRITE SERIAL NO. submode,
respectively.
(1) Make sure that the internal memory has been initialized and the power is off. (For
the initialization procedure, refer to “After completion of reassembling” above.)
(2) While holding down the [Space] and [Clear] keys, press the [ON/OFF] key to
turn the machine on. When releasing those keys, be sure to first release the [ON/
OFF] key and then release the [Space] and [Clear] keys.
The machine enters the inspection mode and displays the following on the LCD:
Figure 3.2-1
FACTORY CHECK