Brother P-Touch PT-2730, Руководство по обслуживанию

Страница: 79 / 105

III - 59
3.3.4 PRINT 1 mode ([5] key)
Use the “24mm laminate black ink ribbon tape”.
After completion of printing of the “Figure 3.3-21”, display the “Figure 3.3-28” by
pressing the
[5] key.
Figure 3.3-28
Start the printing by pressing the below key. The display is the “Figure 3.3-28”.
Shift to the “CUT mode” after completion of printing. (display the “Figure 3.3-31”.)
* Europe/North America specifications: [OK] / [ENTER]
<Print sample>
Figure 3.3-29
The print length should be 100.0 ± 5 mm.
If the print length is out of the specified range, adjust the variable resistor on the main
PCB by using a flat screwdriver as shown on the figure below.
Figure 3.3-30 Adjusting the Print Length by Rotating the Variable Resistor
PRINT 1
* Print length is 100.0mm, and margin is small.
100.0mm
Variable resistor
Main PCB