Brother Operating Instructions, Основное руководство пользователя

Страница: 84 / 155

72
Cooling Down
Wait for a while
The temperature of the drum
unit or toner cartridge is too
hot. The machine will pause its
current print job and go into
cooling down mode. During the
cooling down mode, you will
hear the cooling fan running
while the Touchscreen shows
Cooling Down
and
Wait for a while
.
Make sure you can hear the fan in the machine
spinning and that the exhaust outlet is not
blocked by something.
If the fan is spinning, remove any obstacles
that surround the exhaust outlet, and then
leave the machine turned on but do not use it
for several minutes.
If the fan is not spinning, disconnect the
machine from the power for several minutes,
then reconnect it.
Cover is Open.
The top cover is not completely
closed. Close the top cover of the machine.
The fuser cover is not
completely closed or paper
was jammed in the back of the
machine when you turned on
the power.

Close the fuser cover located inside the
back cover of the machine.
 Make sure paper is not jammed inside the
back of the machine, and then close the
fuser cover and press
Start
(see Paper is
jammed at the back of the machine
on page 79).
Drum !
The corona wires on the drum
units must be cleaned. Clean the corona wires on the drum units (see
Cleaning the corona wires on page 51).
The drum unit or the toner
cartridge and drum unit
assembly is not installed
correctly. Put the toner cartridge into the drum unit that is
indicated on the Touchscreen. Then reinstall
the toner cartridge and drum unit assembly into
the machine.
Drum End SoonX
1
1
(
X
) shows the drum
unit color that is near
the end of its life.
(BK)=Black,
(Y)=Yellow,
(M)=Magenta,
(C)=Cyan.
The drum unit for the color
indicated on the Touchscreen
is near the end of its life. Order a new drum unit for the color indicated on
the Touchscreen before you get a
Replace DrumX
message.
Drum Stop
It is time to replace the drum
unit. Replace the drum unit for the color indicated on
the Touchscreen. (see
Replacing the drum
units on page 55).
Fuser Error
The temperature of the fuser
unit does not rise to a specified
temperature within the
specified time.
Press and hold down to turn the machine
off, wait a few seconds, and then turn it on
again. Leave the machine idle for 15 minutes
with the power on.
The fuser unit is too hot.
Jam 2-sided
The paper is jammed
underneath the paper tray or
the fuser unit. See Paper is jammed underneath the paper
tray on page 84.
Jam Inside
The paper is jammed inside the
machine. See Paper is jammed inside the machine
on page 81.
Error Message Cause Action