Brother Innov-is NV4000D, Руководство по обслуживанию

Страница: 230 / 381

3 - 98
Module Needle thread module
4
Rack assembly attachment
1. Place the rack assembly
1
in the unit assembly.
*Key point
• Lift the right end of the rack assembly, and then insert it from
the left side.
• Align the rack assembly gear 2 with the drive gear 3 (smaller
diameter).
• Insert the shutter 4 of the rack assembly into the groove 5
on the unit assembly.
2. Attach the trigger
6
to the rear of the trigger plate
7
on the rear of the
rack assembly.
*Key point
• Hang the trigger tab 8 over the screw 9 that extends to the
rear of the rack assembly (longest among the three screws).
3. Attach the retaining ring (E3) to the outer groove on the guide shaft
@
.
4. Apply a light covering of MOLYKOTE EM-30L to the surface of the
guide shaft
@
.
5. Insert the guide shaft
@
from the right shaft hole on the unit assembly.
*Key point
• Insert the guide shaft into the right shaft hole, passing through
the rack assembly and the trigger on the unit assembly, until it
reaches the left shaft hole on the unit assembly.
6. Attach the retaining ring (E3) to the inner groove on the guide shaft
@
.
Start movie clip (CD-ROM version only)
7
6
1 2
5 3 4
8 9
6 : Retaining ring E3
: Retaining ring E3