Brother Innov-is 700E, Руководство по эксплуатации

Страница: 81 / 88

Troubleshooting 79
3
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
This message is displayed when the embroidery unit is trying to
initialize while the embroidery foot is lowered.
The needle position button or thread cutter button was pressed while
the bobbin winder shaft is moved to the right.
A pattern is being stored.
The start/stop button was pressed when no pattern is selected.
Bobbin thread has run out.
Little bobbin thread remains.
When the embroidery unit is attached, and then the machine is turned
on.
You tried to set a number of characters that will not fit within the frame.
The upper thread has become tangled around the bobbin case, and the
needle is bent and hitting the needle plate, etc., so the machine stops
(refer to page 74).
A card that cannot be used with this machine has been inserted, and
you tried to select a pattern from the card.
An embroidery card incompatible with this machine was inserted and a
pattern on the card was selected.
You try to retrieve a pattern downloaded as one for a different machine.
The combined character pattern is too large for the embroidery frame.
You can rotate the pattern 90 degrees and continue combining
characters.
Error Message Probable Cause