Brother HL-4040CN, Руководство по обслуживанию

Страница: 277 / 341

Confidential
5-5
1.4.3 Worker Switch (WSW) Setting and Printout
[ 1 ] Worker Switch Setting (Function code 10)
<Function>
The following worker switches activated with the procedures using the control panel buttons
allow you to set. The worker switches have been set at the factory in conformity to each
country.
CAUTION:
DO NOT change any other worker switches except below.
Worker Switches
WSW No. Function Refer to:
WSW54 PictBridge command delay time App. 1-2
WSW55
Interval of time required for the developing bias voltage
correction
App. 1-2
PS emulation function setting (HL-4040CN only) App. 1-3
WSW56
“Last Job Reprint” function setting App. 1-3
* Details of Worker Switch (WSW)
Refer to APPENDIX 1 . The service personnel accessible selectors of the worker switches are
shaded.
<Operating Procedure>
(1) Press the or button to display “MAINTENANCE 10” on the LCD in the initial stage of
the maintenance mode. Then, press the OK button.
(2) The machine displays “WSW00” on the LCD and becomes ready to accept a worker
switch number.
(3) Press the or button to select the desired number from the worker switch numbers.
Then, press OK button.
(4) The following appears on the LCD.
(5) Enter the desired number on the Selector 1 by pressing button as “1” or button as
“0”.
(6) The cursor moves to the right onto the Selector 2. Repeat to enter the desired number as
described step (5) until the modification for the desired worker switches is completed till
the Selector 8.
* Press the Back button to go back to the previous selector if there is a mistake. Then,
enter the desired number again.
(7) Press the OK button. This operation saves the newly entered selector values onto the
EEPROM and readies the machine for accepting a firmware switch number. The machine
displays “WSW00” on the LCD again to accept a worker switch number.
(8) Press the Cancel button to return to the machine to the initial stage of the maintenance
mode.
Note:
- To cancel this operation and return to the machine to the initial stage of the maintenance
mode during the above procedure, press the Cancel button.
- If there is a pause of more than one minute, the machine will automatically return to the initial
stage of the maintenance mode.
Selector 1
Selector 8