Brother HL-2600CN Series, Техническое справочное руководство, Страница: 196 / 491

2009/06/29
CHAPTER 4 HP-GL/2 - 50
10 ' -Character Slant-
20 WIDTH "LPT1:", 255
30 LPRINT CHR$(27); "E";
40 LPRINT CHR$(27; "%0B";
50 LPRINT "IN;SP1;";
60 LPRINT "SD1,21,2,1,4,25,5,0,6,0,7,5;SI0.7,1;"
70 LPRINT "PA1000,1000;DT#,1;SL0.36,LBPrinter#"
80 LPRINT "PA1000,300;SL-0.36;LBPrinter#"
90 LPRINT CHR$(27); "%0A";
100 LPRINT CHR$(27); "E";
110 END
<Sample 59>
SB - Scalable or bitmap fonts
SB [ n ] [;]
n : font category selection
•
This command enables you to restrict the range of selectable fonts to scalable fonts and the stick font only.
•
n can be 0 or 1. If n = 0 you may only select scalable fonts (or the stick font). If n = 1 you may select any
type of font.
•
An SB command can alter the current standard and alternate font selections.
•
Setting n to 1 allows the selection of bitmapped fonts and has the following side-effects:
•
Bitmap characters cannot be edged.
•
Bitmap characters can only be printed in orientations of 0°, 90°, 180° or 270°.
•
The SL (character slant) command is not applied to bitmap fonts.
•
Bitmap font character sizes are approximate only.
•
The DF and IN commands set n to 0, - only scalable fonts and the stick fonts may be selected.
•
The FI and FN commands implicitly set n to 1 if you use either of them to select a bitmap font.
•
If you omit n from the command, only scalable fonts and the stick font may be selected. This is
equivalent to an SB0; command.
•
The default setting is scalable fonts and stick font only.
ES - Extra space
ES [ width [, height ]] [;]
width : factor by which character spacing is changed.
height : factor by which line spacing is changed
•
This command enables you to adjust the space between label characters and lines.
•
width specifies the factor by which to increase or decrease the character spacing. Positive numbers specify
an increase and negative numbers a decrease.
•
height specifies the factor by which to increase or decrease the line spacing. Positive numbers specify an
increase and negative numbers a decrease.
•
If you use the command without parameters, no extra space is used when labels are printed. This is
equivalent to ES0,0;
•
An ES command remains in effect until another ES command is executed, a DF or IN command is
executed or the printer is reset, either with the EscE command or from the control panel.
TD - Transparent data
TD [ mode ] [;]
mode : normal or transparent data mode.
•
This command enables you to specify whether control characters should perform their normal function
or should be printed.