Brother CS8000 Series, Руководство по обслуживанию

Страница: 124 / 208

3 - 52
Needle-presser module Modules
8
Z zigzag cam attachment
1. Install the Z zigzag cam
1
on the Z zigzag cam shaft, and attach retaining
washer E2.
*Key point
• Align the match mark 2 on the Z pulse motor gear and the
match mark
3
on the Z zigzag cam.
2. Apply a small amount of Molykote EM30L to the Z zigzag cam
1
gear
part and cam part.
Start movie clip (CD-ROM version only)
Apply Molykote EM30L grease to all of the sliding
part of the Z zigzag cam pin Small amount
Apply Molykote EM30L grease to all of the Z zigzag cam Small amount
Apply Molykote EM30L grease all around the Z zigzag cam gear Small amount
3
2 1
Retaining ring E2
9
Thread releaser assy. attachment
1. Apply Molykote EM30L to the thread releaser assy.
1
.
2. Attach the thread releaser assy.
1
to the upper unit holder.
*Key point
• Align the thread releaser assy. 1 pin 2 and upper unit holder
hole and the thread release lever pin
3
and the round hole
4
in the thread releaser assy. 1 .
Start movie clip (CD-ROM version only)
Apply Molykote EM30L grease to all of the sliding
parts of the thread releaser assy. (1). Small amount
1
2
3 4
10
Z zigzag lever assy. attachment
1. Attach the cap to the Z zigzag lever assy.
1
.
2. Apply a small amount of Molykote EM30L to the Z zigzag lever assy.
1
pins (two).
3. Attach the Z zigzag lever assy.
1
to the upper unit holder, and attach
retaining ring E3.
*Key point
• The end 2 of the Z zigzag lever 1 goes on the left side of the
Z zigzag cam
3
.
Start movie clip (CD-ROM version only)
Apply Molykote EM30L grease to the two pins on
the Z zigzag lever Small amount
Retaining ring E3
1
2 3
www.promelectroavtomat.ru