Brother 888-L90, Руководство по эксплуатации

Страница: 72 / 101

Adjustments During the Embroidery Process
Embroidering E-23
EM
BRO
ID
ER
Y
E
If the bobbin runs out of thread
When the bobbin begins to run out of thread during
embroidering, the machine will stop and the message below
will appear. If very little sewing remains, you can embroider
approximately 10 final stitches without rethreading the
machine by pressing and restarting the machine. The
machine will stop after sewing approximately 10 stitches.
a
Raise the presser foot lever.
b
Cut the threads and press .
→
The screen changes, and all keys and operation
buttons are locked (except ).
c
While pushing the lever of the embroidery frame
holder to the left, slightly lift the back and then the
front of the embroidery frame up to clear the pins, and
then remove the frame.
Hold the lever lightly to the left.
• Be careful not to apply strong force to the fabric at
this time. Otherwise, the fabric may loosen in the
frame.
1
Lever
Remove the back mounting bracket from the pin.
1
Back mounting bracket
2
Back pin
Remove the front mounting bracket from the pin.
1
Front mounting bracket
2
Front pin
d
Remove bobbin cover and insert a wound bobbin into
the machine. (see “Installing the bobbin” of “Basic
operations”.)
e
Reattach the embroidery frame.
f
Press to unlock all keys and buttons.
g
To return to the area in the pattern where you stopped
sewing, follow steps
c
through
f
in the next
section.
Adjustments During the Embroidery Process
Note
• Be careful not to bump the embroidery unit
carriage or the presser foot when removing or
attaching the embroidery frame. Otherwise, the
pattern will not embroider correctly.
a
a
b
a
b