CHARGING THE BATTERY
Charge the battery before first use. A full charge takes
approximately 1.5 hours. After charging, the device can be used
without the power connection. When the battery is low, the LED
indicator flashes red three times periodically, and a low battery
warning repeats every 18 seconds.
If the device is not used for an extended period of time, the
battery may require recharging.
To charge the battery:
1. Plug the USB connector into a USB port on an active device.
2. Plug the Micro USB end of the USB connector into the
Micro USB port on the earphones. The LED light turns red
during charging. The light turns blue when the earphones
are fully charged.
6
7
PAIRING WITH BLUETOOTH
®
To pair for first-time use:
1. Prepare your device (e.g., smartphone) to pair using
Bluetooth
®
, making sure that the device is within 33 feet
of the earphones. Refer to your device's owner’s manual for
information on using the Bluetooth
®
function.
2. Press and hold the earphone's Multi-Function Button (MFB)
for about 5 seconds, until the LED alternates between red
and blue, indicating that the earphones are in pairing mode.
3. On your device, search the list of available devices and
select Reverse Sound. Note that it may take a few seconds
for the earphones to be listed as an available device.
Depending on your device, you may have to tap SCAN to
update the device list. Consult your device's owner's manual.
4. If prompted, type the password or PIN 0000.
A message will display on your device confirming that your
device is now paired/connected and the earphone's LED will
flash blue every 10 seconds, indicating that the device is paired.
The devices will remain paired, even after being turned off.
When you next power on the earphones, they will search
for previously paired devices. To cancel pairing, consult your
device's owner's manual.
The Bluetooth
®
word mark and logos are registered trademarks owned by Bluetooth
SIG, Inc. and any use of such marks by Brookstone is under license.
