Brooks Electronics EIB603CX, Руководство пользователя

Страница: 13 / 30

3. Installation
Installation Procedure
1. Select a location complying with the advice in Section 2.
2. The mounting plate (base) is supplied with an interface board to supply power
to the Alarm and communicate with other Alarms and the residential panel. (see
Figure 5).
3. Place the mounting plate on the ceiling exactly where you want to mount the
Alarm. With a pencil, mark the location of the two screw holes.
4. Run suitable 3 core cabling to the marked
locations of each Alarm. Make the connections
to the interface card (see Section 4).
5. Taking care to avoid any electrical wiring in
the ceiling, drill holes using a 5.0mm drill bit
through the centre of the marked locations.
Push the plastic screw anchors provided into
the drilled holes. Screw the mounting plate to
the ceiling.
6. Terminate the field wiring from the previous
alarm or the RFAP into the interface PCB
mounted inside the mounting base.
7. Carefully line up the unit on the base,
gentle press home & twist on.
13
ROTATE UNIT ANIT-CLOCKWISE
UNIT WILL NOT TWIST OFF - IT MAY BE
TAMPERPROOFED - SEE FIGURE 8c
Figure 5