Bronpi Air Series, Инструкции по установке, эксплуатации и обслуживанию, Страница: 37 / 138

36
9.5 USER MODE
Below is a description of the display normal operation according to
the available functions.
Before the ignition of the stove, the display shows the following
screen ( see drawing D57 ): It is showed up the “off” state, the room
temperature, the established working power and the current hour.
9.5.1 IGNITION OF THE STOVE
In order to ignite the stove, press button no.4 during a few seconds.
The display will show the ignition state as follows (
see drawing D58
):
The maximum length of the ignition phase is 20 minutes. After this
time, if there is no visible flame, the stove will automatically go into
the alarm state and the display will show the message “Ignition
Failure.”
9.5.2 STOVE IN OPERATION
The hot air fan will start when the smoke temperature reaches a
minimum. Auxiliary fans (in case of models of stoves Lola, Sara,
Clara Extra, Cleo Extra and Olivia Extra) will start only if enabled.
In this moment, the display will show the message “Work.” After this,
our stove will be working normally ( see drawing D59 ).
The display shows the ambient temperature in the room.
9.5.3 Change of the set-point room temperature
In order to modify the setting room temperature, please press button
1 and 2 to increase or decrease it respectively (
see drawing D60
).
9.5.4 ROOM TEMPERATURE REACHES TEMPERATURE
FIXED BY THE USER
When the ambient temperature (of the room) reaches the value set
by the user or the smoke temperature reaches a too high value, the
stove will automatically operate at one lower power; it means that
modulates in power. See drawing D61.
Remember that if it is activated “stand-by mode”, when the ambient
temperature reaches the value set by the user plus a differential
(2ºC) the stove will be automatically turned off and will be on hold
until the ambient temperature falls to the set temperature minus a
differential (2ºC). After that, the stove restarts automatically.
9.5.5 BURNER CLEANING
While the stove is working normally, some automatic cleanings of
the burner take place in 30 minutes intervals. This process consists
of cleaning the rest of pellet remaining in the burner in order to
guarantee a proper working of the stove ( see drawing D62 ) and it
takes 30 seconds.
9.5.6 TURNING OFF THE STOVE
In order to turn off the stove, press button no.4 during a few seconds. Once it has been turned off, it will start the final cleaning stage, in
which the pellet supply stops and the smoke extractor will be working
to the maximum speed. This stage would not finish until the stove has
reached the appropriate cooling temperature ( see drawing D63 ).
D55
LOAD
AUGER SPEED POWER
DIALOGUE
AL 8
D56
FAILURE
ASPIRATION
STATE ALARM IN PROCESS
14:24
21 ºC P-2
D57
OFF
14:35
21 ºC P-2
D58
IGNITION
15:18
21 ºC P-3
D59
WORKING
24 ºC
SET TEMP
D60
ROOM
27 ºC P-2
16:40
D61
WORKING
MODULATION
22 ºC P-2
16:40
D62
BURNER
CLEANING
23 ºC P-3
21:10
D63
FINAL
CLEANING
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS AIR SERIES
EN