BRONKHORST E-7000 Series, Инструкция по эксплуатации

Страница: 12 / 33

BRONKHORST HIGH-TECH B.V.
page 12 9.17.017
1.5 Connector panel 1000 Watt power supply 42Vac power supply
mains
input
(1)
from T-control
module
(2)
to CEM
(3)
to CEM
(male) (female)
Connector panel separate power supply
connector (1)
Pinnumber description
A
B
C
D
E
F
NC
NC
PT100 (T-sensor)
PT100 (T-sensor)
Heater control signal
Heater control signal
connector (2)
pinnumber Description
A
B
C
D
E
F
NC
NC
PT100 (T-sensor)
PT100 (T-sensor)
safety switch
safety switch
connector (3)
Pinnumber description
A
B
C
D
E
F
Heater 1
NC
Heater 2
Heater 1
NC
Heater 2
1.5.1 EMC and cables
All system setups described in this manual carry the CE-mark. Therefore they have to comply with the EMC
requirements as are valid for this kind of equipment.
However compliance with the EMC requirements is not possible without the use of proper cables and
connector assemblies.
For good results Bronkhorst HIGH-TECH B.V. can provide standard cables. Otherwise follow the guidelines
as stated below. For cables with 9-pin sub D-connectors: